JakefaceCustoms
Hyte Y60 Custom Vented Side Panel
Hyte Y60 Custom Vented Side Panel
Couldn't load pickup availability
Replace the side glass panel on your Hyte Y60 with this Custom Laser cut vented replacement! These vented acrylic panels improve airflow! This panel is made from acrylic, which provides extra rigidity and strength. All panels are made to order and custom designs are available if requested. The panels are held in place with mounting pegs like the original panels, which allow for easy installation and removal. No modding is required to the original case/panel.
Designed to work with the Hyte Y60 only
PAINTED BORDER, hides the frame.
Installation:
- Remove the original panel
- Simply place my panel on!
COLORS AVAILABLE:
Transparent smoke grey:
#2064 transparent smoke acrylic. A little darker than the original glass.
Clear:
Just standard clear acrylic.
*All panels are shipped with the paper still attached to prevent scratches during shipping.
*This listing is for a side panel only, case is not included, front panel not included.
Materials: Acrylic,resin
Collapsible content
Installation
H510 Side Panel
If your new panel isn't fitting easily or you have a newer
model, check the front left corner of the case near the
bottom. There may be a metal tab blocking installation.
Simply bend down that tab in order to have an even fit.
H510 Front Panel
Remove both side panels. On the upper part of the case,
there is a little screw on either side that must be removed
for the original panel to pop off.
If the replacement panel is not fitting easily, especially if
you have a newer model: check the front of the case near
the left side for a small plastic wedge piece. This wedge
serves no purpose and must be removed for the front
panel to fit as intended.
H1 Front Panel
Before installation, remove the six rubber pads on the
front of the case (beneath the factory panel.)
Optional Fan Filters
If you purchased fan filters, these can be installed on the
front or back of your fans using the existing screws
already holding your fan in place.
A4H2O, Meshilicious, Q58, Ncase M1 and any other panel
with pins/pegs:
CAREFULLY and GENTLY install and remove!
Install: line up the pins and they should easily pop into
place (Don't smash!)
Remove: Remove carefully, one pin at a time while
keeping the panel close to the case. Do NOT yank or rip
the panel off from an angle or one side!
TIPS
- Installs like the stock panel!
- No modding required!
SHIPPING
- All international orders include Insurance
- International customers: Tax, duties/VAT may be collected at time of delivery.